Table of Contents
Advertisement
2.4
SCAN MODULE INSTALLATION
Ensure that the latches on the KD6i are in the locked position. See
Hold the KD6i scan module by the liner mounting bracket, the liner itself, or the
latches. DO NOT HOLD THE KD6i SCAN MODULE BY THE CAMERA. Locate the
yellow sticker with a black dot in the center on one of the latches on the scan module.
Align this sticker with the same sticker in the back can module or top dome. The KD6i
narrow mounting slot aligns with the three small scan alignment studs in the back can
module and the wide mounting slot aligns with the two large scan alignment studs in
the back can module. The connector on the top of the scan module aligns with the
connector in the top of the back can module or top dome.
Push the KD6i scan module into the back can module until both latches click into the
holes on the back can module. You should hear two clicks. Press firmly on both
latches to ensure proper installation. Gently tug on the scan module to verify it is
locked in position.
NOTE: The hard ceiling back can module is shown. Installation of the KD6i scan
Rev. D
module in the Dropped Ceiling, Pendant, and Weather back can modules is
the same. Installation of the lower dome module depends on whether the
lanyard is installed at the factory on the lower dome or on the top dome (as
shown below). Refer to
The bottom weather dome is not shown. Refer to
of the bottom weather dome.
Figure 3
or
Figure 5
depending on your equipment.
11
Figure
3, Detail A.
Figure 6
for an illustration
KDMU000799
02/6/04
Advertisement
Table of Contents
