Table of Contents
Advertisement
4.1
INTRODUCTION
The UltraDome KD6i pan and tilt units feature on-screen menus for setting up the
receiver board and for enabling special features available for customer use.
All units are set up at the factory before shipment; but can be easily changed in the
field using the on-screen menus.
Refer to your system controller user manual for the keystrokes to access the KD6i
setup menu and the keystrokes to navigate through the options.
Examples:
•
When using a JPD-100 Diamond series controller and a KBD-100 keyboard,
press SHIFT+F1 to access the KD6i setup menu.
•
When using the MXSYS04E and a KEGS5000 controller,
press
Use numeric keys on the controller to access menu options.
Press
Press
•
When using a Maxpro, VCL, Pelco P, Pelco D, or Burle controller send the scan
to PreShot 90. When using an American Dynamics controller, send the scan to
PreShot 61. To select a menu option when using these controllers, use the tilt up
and down function on the controller to move the cursor to the desired number
beside the option, then press Iris Open. The pan left and right commands may
also be used to move horizontally between fields in a table. The Iris Close
function is used to exit (ESC to exit) menus
•
When using an UltraKey (with default menu programming):
To access menu options, use the numeric hard or soft keys on the controller.
The ESC soft key sends an ESC command and exits the KD6i menu.
The EXIT soft key removes the UltraKey from the KD6i menu mode.
•
The menu options either toggle between the available choices or call up another
menu.
Rev. D
SECTION 4:
NAVIGATING MENUS
to access the KD6i setup menu.
to send an ESC command to the KD6i and exit the KD6i menu.
to remove the KEGS5000 from the KD6i menu mode.
1. Press the MENU soft key (on left side of screen).
2. Press the Dome Setup soft key on the screen.
3. Press the ENT (hard) key.
17
KDMU000799
02/6/04
Advertisement
Table of Contents
