Table of Contents
Advertisement
5.6
FUNCTION PROGRAMMING, CONTINUED
5.6.2
VectorScan
Position the cursor on 2 and press
Iris Open to program a VectorScan.
This menu option is only displayed when
Maxpro, VCL, Pelco P, Pelco D, Burle, or
American Dynamics protocol is selected on
the DIP switch on the scan.
VectorScans 0-9 can be programmed and assigned to alarms or the default function.
VectorScans 1, 2, & 3 can be started using PreShot commands 87, 88, and 89
respectively.
1.
Use the tilt up function on the joystick until the desired VectorScan number (0-9) is
displayed, then press Iris Open.
2.
Use the tilt up and down and the pan left and right functions of the controller to
move between fields.
FIELD
NUM (number)
PRESHOT
VELOCITY
DWELL
Rev. D
Program VectorScan •
↑↓ to scroll/
Press Iris Open when done
Move the cursor to the desired field and press Iris Open to activate.
Use the tilt up and down functions of the controller to change the value.
If the field is more than one digit, each digit can be changed individually
by placing the cursor on the digit and using the tilt up or down function.
Selectable from 0 to 79. PreShots 80-99 are reserved for special
functions and cannot be entered in a VectorScan. When the field has the
desired number, press the Iris Open to select the number.
Iris Open also moves the cursor to the next field
The Velocity field is the pan and tilt speed for the scan to go to the
PreShot (1 to 400°/second.) The default is 400°/second.
The dwell time is how long the scan waits before it goes to the next
PreShot in the list (0 to 99 seconds.)
43
FUNCTION PROGRAMMING
1 PTZ Tour
2 VectorScan
Program VectorScan n
NUM
PRESHOT VELOCITY
1
__
__
2
__
__
3
__
__
4
__
__
5
__
__
6
__
__
7
__
D = Delete
E=ExitS=Save
Usage
DWELL
__
__
__
__
__
__
__
KDMU000799
02/6/04
Advertisement
Table of Contents
