Table of Contents
Advertisement
5.3
CONTROL OPTIONS, CONTINUED
Rev. D
Pan Offset Setup
1.
Offset – Select 1 to toggle the
offset ON or OFF. For the
scan to adjust the positioning
of the scan to the programmed
pan offset, the offset must be
set to ON.
2.
Set Pan Offset – Once Offset
is ON, perform the following
steps to set pan offset:
* You must know the original positioning of PreShot 0.
1.
ESC out of the KD6i setup menus until you have manual control of
the scan.
2.
Send the scan to PreShot 0. If it does not go to the previously
known position for PreShot 0, the offset function can be used.
3.
Using the controller, position the scan for PreShot 0.
4.
Access the KD6i MAIN MENU
4. Pan Options
5.
Select 2 to set the pan offset. To test the setting, reposition the
scan, the send the scan to PreShot 0. The scan should return to
the position programmed in step 3.
Press ESC to exit the Pan and Tilt Options menu.
1 Offset ...................................... ON
2 Set Pan Offset
ESC to Exit
3. Control Options
6. Pan Offset.
29
Pan Offset Setup
KDMU000799
02/6/04
Advertisement
Table of Contents
