Table of Contents
Advertisement
Introduction
This document provides instructions for configuring the HD3US(X) minidome camera
settings. These instructions are intended for system installers, administrators, and
operators. For information about installing the camera, refer to the HD3US(X) Ultra WDR
Indoor Minidome Camera Quick Installation Guide (800-13598).
Programming the Camera
The camera is programmed using the on-screen display (OSD) menus. You can connect a
portable monitor during installation using the supplied adapter cable.
To show the OSD main menu, press the OSD
controller joystick located on the camera
UP
control board.
Move the joystick up or down to navigate
LEFT
RIGHT
through the menu options. Move the joystick
right to change a menu setting.
DOWN
When a menu option or setting is followed by
two dots (..), press the joystick to access the
next screen. To go back to the main menu,
select RETURN.., and then press the joystick.
4
Advertisement
Table of Contents
