Editing Vectorscans; Deleting Vectorscans - Honeywell UltraDome KD6i Series User Manual

7.3 PROGRAMMING VECTORSCANS, CONTINUED
5. Enter the velocity from 1 to 400 (degrees per second) in the VELOCITY column
of the 0 row.
6. Type the dwell time from 0-99 seconds.
7. Continue entering PreShots, up to 64, by repeating steps 4 through 6.
PreShots will be performed in the order listed. To rearrange the order of the
PreShots, use the gray up, down, left, and right arrow keys to move the cursor to
any field in the display. The gray Insert key inserts a line above the cursor.
The gray Delete key deletes the line the cursor is on.
8. Press Enter when finished programming PreShots in the VectorScan.
9. Repeat steps 2-8 to program another VectorScan or press ESC to end
programming.
7.3.1

Editing VectorScans

1. Press SHIFT + F6
2. Type the VectorScan number and press Enter.
3. Edit the PreShot fields as needed. (Refer to
4. Press S to save the edits.
5. Press ESC to exit programming.
7.3.2

Deleting VectorScans

1. Press SHIFT + F6.
2. Type the VectorScan number and press Enter.
3. Press Enter to accept the VectorScan title.
4. Press Enter to access commands.
5. Press D to delete the VectorScan.
6. Press ESC to exit programming.
Rev. D
a. Press E to edit the VectorScan title and/or the contents before saving.
b. Press S to save the VectorScan title and programmed PreShots.
c. Press D to delete the VectorScan.
Section 7.3, step
56
7.)
KDMU000799
02/6/04