Defining Protocol (Switches 1-4) - Honeywell UltraDome KD6i Series User Manual

2.2 SCAN MODULE INSTALLATION, CONTINUED
2.2.1

Defining Protocol (Switches 1-4)

Standard Diamond
Maxpro
MUX100
AD
Pelco P
VCL
Pelco D
iPro
Pelco P_AD
Pelco D_AD
Javelin equipment
KD6i with an AD1281/1 Code
Distributor
KD6i with a Sennetech Code
Translator, Model SCT-1036
KD6i with the Manchester
Code Interface Board and an
AD control system
KD6i with the Manchester
Code Interface Board and a
Burle control system
KD6i with the Digital Interface
NOTE: If the switches are set to something other than the above settings, the scan
Rev. D
Protocol 1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
Equipment
defaults to Standard protocol.
The standard Pelco P and D selections use special PreShots numbered in
the 80's and 90's. The Pelco P w/AD PreShots and the Pelco D w/AD
PreShots selections set the protocol for Pelco P and Pelco D code
respectively, but use special PreShot numbers less than 32 for KD6i menus
and setup.
2 3
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF OFF
OFF ON OFF
OFF ON OFF
ON ON OFF
ON ON OFF
OFF ON
ON ON
Protocol
Set the Javelin controller for Diamond protocol and
set the KD6i unit for Maxpro protocol.
Set the KD6i to American Dynamics protocol.
Set the KD6i to Maxpro protocol.
Set the KD6i to American Dynamics protocol.
Set the KD6i to Maxpro protocol.
Set the KD6i address to 000 and the control system
to UPF. Set the KD6i to standard (Diamond)
protocol.
6
4
ON
ON
KDMU000799
02/6/04