Table of Contents
Advertisement
7.5
PROGRAMMING PRIVACY ZONES, CONTINUED
1. Press SHIFT + F8.
2. Select P for privacy zone.
Factory set
3. Type the password and press Enter.
password
4. Type the desired privacy zone number (0-9) and press Enter.
5. Type the title (up to 24 alphanumeric characters) to be displayed on the monitor
6. The following options are available:
7. Press S to program and save sector
8. Using the controller, move the scan
9. Using the large joystick on the controller, move the scan so the upper right
10. The privacy zone is programmed for all points between the selected coordinates
11. Program another privacy zone or press Esc twice to exit programming.
Rev. D
(The factory set password is blank. Press enter to submit a blank password.)
when viewing the privacy zone and press Enter. If the zone has already had a
title programmed, the current title is displayed.
E to edit the title
S to program zone coordinates
D to delete zone coordinates
N to save privacy zone title only
coordinates.
so the lower left corner of the sector
is centered on the monitor, then
press Enter. (The crosshair function
may be helpful in determining the
center of the monitor.)
corner of the sector is centered on the monitor, then press Enter. If the upper
right tilt position is below the lower left tilt position, the message "Illegal Tilt
Direction" is displayed. Readjust the tilt position until the message disappears or
press ESC to cancel the operation and return to manual operation.
as shown in the above diagram.
Lower
left
59
Upper
right
KDMU000799
02/6/04
Advertisement
Table of Contents
