Flicker, Shadows Or Dimness; Lamploc™ Does Not Seem To Work; Liteloc Does Not Seem To Work; Ils - Christie Solaria CP2210 Setup Manual

5.2.3 Flicker, Shadows Or Dimness

1. Ensure the douser is OPEN completely.
2. LampLOC™ may need re-adjustment.
3. LampLOC™ may be in the middle of its adjustment. Wait until LampLOC™ completes.
4. Adjust LampLOC™. In the Advanced Setup: LampLOC™ Setup window, click the
5. Check the lamp power in the Advanced Setup: Lamp Power/LiteLOC™ Setup window to see if the
power is consistent or varying. Try to increase lamp power, if possible. Lamps which are near end of life
may not operate reliably at lowest power range.
6. Fold mirror misalignment (Christie service required).
7. Integrator rod misalignment (Christie service required).
5.2.4 LampLOC™ Does Not Seem to Work
If the Do Auto LampLOC
adjusting the lamp position manually by clicking the
region. Watch the light level for changes indicating lamp movement, both on the TPC readout and on screen
with a white test pattern.
5.2.5 LiteLOC Does Not Seem to Work
™
1. In the Advanced Setup: Lamp Power/LiteLOC™ Setup window, ensure LiteLOC™ is enabled.
2. If the lamp power has increased to its maximum in order to maintain a LiteLOC™ setting, LiteLOC™ is
automatically terminated. If the values shown in the Advanced Setup: Lamp Power/LiteLOC™ Setup
window indicate that the lamp power has reached this "over-drive" state, either reduce your LiteLOC™
setting or install a new lamp.
5.3

ILS

5.3.1 Reset the ILS

The ILS must be reset when:
• the lens has been physically bumped or moved
• manual adjustments have been made to horizontal/vertical offset, zoom or focus
• a power outage or brown-out occurred during a channel change
• ILS settings are drifting within a short period of time
To reset the ILS, click the
button is selected when
Quick Reset
remembered setting.
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)
function does not work in the Advanced Setup: LampLOC™ Setup window, try
™
button from the Advanced Setup: Lens Setup window. NOTE: If the
Quick Reset
Enable Automatic ILS
Section 5: Troubleshooting
up/down/left/right/in/out
is NOT selected, the lens will return to the
button.
Do Auto
buttons in the LampLOC
™
5-3