Christie Solaria CP2210 Setup Manual page 44

Section 4: Maintenance
extreme caution - the lamp is hazardous even when packaged. Dispose of lamp box
according to local area safety regulations.
g. With the lamp removed, visually inspect the reflector for dust. If necessary, clean the reflector, as
described in
Remove the new lamp from the protective case. NOTE: Before removing the lamp from the case loosen
5.
the cathode screw and remove the cathode nut from the lamp.
6. Install new lamp.
NOT over-tighten. DO NOT stress the glass in any way. Check leads. Ensure the anode (+)
lead between the lamp and ignitor is well away from any projector metal, such as the reflector
or firewall.
a. Remove the cathode clamp from the lamp before removing it from its case.
b. Hold the anode end of the lamp in your left hand and angle it up through the hole in the back of the
reflector assembly. Insert your right index and middle finger through the back front of the reflector and
guide the lamp onto the cathode clamp. Be careful not to hit the lamp against the reflector.
c. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is against the
cathode clamp.
d. Tighten the cathode screw (5./E) onto the cathode end of the lamp, using the hex key, provided on the
rear access door.
e. Align the ring terminal on the anode wire (5./B) with the mounting position (5./D), ensuring the
crimped side of the wire is facing out. Tighten the anode screw. NOTE: Route anode lead away from
nearby metal surfaces.
7. Close the internal lamp door and manually turn the two thumbscrews to lock it in place.
8. Close the rear access door. NOTE: Ensure the hex key is placed back into its holder before closing the rear
access door.
4-6
4.3.4 Cleaning the Lamp Reflector, on page
Figure 4-1 Lamp Assembly
Handle the lamp by the cathode/anode end shafts only, never the glass. DO
4-4.
A
Reflector
B Anode Wire
C Isolator Screws
D Anode Nut
E Cathode Screw
F Cathode Nut
G Cathode Clamp
H
Cathode Wire
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)