Power; Projector Does Not Power On - Christie Solaria CP2210 Setup Manual

Solaria series

Hide thumbs Also See for Solaria CP2210:

Table of Contents

5 Troubleshooting

If the projector does not appear to be operating properly, note the symptoms and use this section as a guide. If

the problem can not be resolved, contact your dealer for assistance. NOTE: A qualified service technician is

required when opening an enclosure to diagnose any "probable cause".

5.1

Power

1. Check the wall circuit breaker to see if it's ON. If there is a

problem with the wall circuit breaker "tripping" OFF, have a

certified electrician investigate any electrical problem.

2. Check the status of the LEDs on the rear corners of the projector.

(Figure 5-1). If there is no activity, see Step 3.

3. Verify power by looking through the non-operator's side front

access panel. One LED should be present in the lower middle

region. This indicates the LVPS has power. (Figure 5-2)

LVPS Power LED

4. On the TPC, verify in the Operational Status region of the Main panel that there is no failure with PIB

communication (PIB Status).

CP2210 Setup Guide

020-100524-02 Rev. 1 (11-2010)

Figure 5-2 View Power Status LEDs

Figure 5-1 Projector Status LEDs

5-1

Table of Contents