Display Is "Noisy; Display Has Suddenly Frozen; Data Is Cropped From Edges; The Projector Is On, But There Is No Display - Christie Solaria CP2210 Setup Manual

Section 5: Troubleshooting

5.6.8 Display is "Noisy"

1. Display adjustment at your input source may be required. From a DVD player or an input module setting,
adjust pixel tracking, phase and filter. Noise is particularly common on YPbPr signals from a DVD player.
2. The video input may not be terminated. Ensure the video input is terminated (75 ohms). If it is the last
connection in a loop-through chain, the video input should be terminated at the last source input only.
3. The input signal and/or signal cables carrying the input signal may be of poor quality.
4. If the distance between the input source device and the projector is greater than 25 feet, signal amplifica-
tion/conditioning may be required.
5. If the source is a VCR or off-air broadcast, detail may be set too high.

5.6.9 Display has Suddenly Frozen

If the screen blacks out inexplicably, it is possible that excessive voltage noise on the AC or ground input has
interrupted the projector's ability to lock on to a signal. Power down the projector and then power back up
again.

5.6.10 Data is Cropped from Edges

To display the missing material, reduce image size to fill the display area available in the projector, then stretch
vertically to fill the screen from top to bottom. Add the anamorphic lens to regain image width. Cropping could
also be due to the screen file selected that has cropping configured.

5.6.11 The Projector is ON, but There is No Display

1. Ensure AC power is connected.
2. Make sure the lens cover is removed from the lens.
3. Make sure the douser is OPEN.
4. If the lamp is not ignited, click the
Not Ignite, on page
Channel Setup: Config 1 window.
5. Is an active source connected properly? Check the cable connections and make sure the alternative source
is selected.
6. Can you access test patterns? If so, check your source connections again.
7. Ensure your Cinema server is running Series 2 compatible software.

5.6.12 The Display is Jittery or Unstable

1. If the non-cinema display is jittery or blinking erratically, ensure that the source is properly connected and
is offering adequate quality for detection. With a poor quality or improperly connected source, the
projector will repeatedly attempt to display an image, however briefly.
2. The horizontal or vertical scan frequency of the input signal may be out of range for the projector. Refer to
Section 6 - Specifications from the CP2210 User Manual (020-100410-xx) for scan frequency ranges.
3. The sync signal may be inadequate. Correct the source problem.
5-6
LAMP ON
5-2. Ensure the correct channel is selected with the appropriate configurations in the
button. If the lamp does not strike, refer to 5.2.1 Lamp Does
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)