2: Installation And Setup; Permanent Power Connection; Tools Required For Installation - Christie Solaria CP2210 Setup Manual

2 Installation and Setup
WARNING
• All installation procedures must be performed by a qualified technician in a restricted access
location.
• Never operate the projector without all of its covers in place.
• Projector uses a high-pressure lamp that may explode if improperly handled. Always wear
manufacturer approved protective safety clothing (gloves, jacket, face shield) whenever the
lamp door is open or while handling the lamp. Lamp installation/replacement requires a
qualified technician.
• Two people are required to safely lift and install the projector.
• When transporting the projector from a cold environment it is essential the projector
acclimatizes to the operating environment before powering up for a minimum of three
hours after unpacking. Failure to ensure the projector has properly acclimatized could
damage projector electronics. This applies to the lamp as well. The lamp will be damaged if
it is powered ON when below room temperature. Lamps should be stored between 25-65°C
(77-149°F).
• Auto LampLOC
levelled.
This section explains how to install, connect and optimize the projector for delivery of superior image quality.
NOTE: Illustrations are graphical representations only and are provided to enhance the understanding of the
written material.
2.1

Permanent Power Connection

WARNING
• A single-phase 20A UL listed connection of AC power suply is required to accomodate the detachable pro-
jector plug.
• The power supply, along with protection from short-circuits must be must be part of the building installation.
• Protective devices are integrated into the equipment.
2.2

Tools Required for Installation

Before you begin installation, it is important to fully understand all site requirements and characteristics, and
that you have the following tools and components on hand.
19mm wrench
Protective clothing/safety gear (required when handling the lamp)
Lamp
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)
must be run any time the projector is physically moved or when it has been
™
No protective device is provided in the neutral conductor.
2-1