Liquid Cooling System; Filling The Coolant Reservoir; Optional: Exhaust Duct (P/N: 119-103105-Xx) - Christie Solaria CP2210 Setup Manual

Section 4: Maintenance

4.2.3 Liquid Cooling System

Check: Every 6 months
The liquid cooler system circulates liquid to and from the DMD heatsinks in the CP2210 reducing the DMD
operating temperature to an acceptable level. Check the coolant level every six months, by removing the top
projector lid and inspecting the coolant reservoir. Make sure the level of coolant remains above the minimum
level indicator. If the liquid cooling system should fail, an over-temperature alarm window will display. If an
over-temperature state remains for more than one minute, the lamp will turn OFF.

Filling the Coolant Reservoir

DANGER
glycol. Use caution when handling. DO NOT ingest.
WARNING
projector. Using unapproved coolant can result in projector damage and will also void
projector warranty.
Top up the coolant with the Christie approved coolant Jeffcool E105. Use the refill bottle (with the nozzle)
provided in the Liquid Coolant Fill Service Kit (P/N: 003-001837-xx). When refilling, use caution not to spill
or let any of the coolant drip on or near the electronics. Do not allow the level of coolant to fall below the
Minimum Fill Line. NOTE: After filling the reservoir, check the coolant hoses for kinks which may restrict
fluid flow.
In the event coolant drips on any electronics or other nearby components, blot the affected area using a
dust-free optical grade tissue. It is recommended you blot a few times, discard the tissue and use a new tissue to
blot the area again. Keep repeating this cycle until the coolant is cleaned up. Then lightly moisten a new tissue
with de-ionized water and blot the area again. Use a dry tissue to dry the area off. Repeatedly using clean tissue
and blotting the area should successfully remove coolant spills.

4.2.4 Optional: Exhaust Duct (P/N: 119-103105-xx)

Check: Every 6 months
If used, check exhaust duct to ensure it is clean and unobstructed.
4-2
HAZARDOUS SUBSTANCE! The coolant used in this product contains ethylene
=
DO NOT use coolants other than that specified by Christie with your
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)