Other Components; Lamp Blower; Lamp Replacement - Christie Solaria CP2210 Setup Manual

4.3.5 Other Components

In a normal operating environment check, clean and treat the components listed below every 6 months or so to
help ensure proper lamp and projector function.

Lamp Blower

NOTICE! DO NOT bend the impeller blades or loosen any balancing weights.
A clogged lamp blower impeller or motor can reduce air flow leading to possible overheating and lamp failure
of the lamp.
1. Vacuum loose dirt from the lamp blower impeller.

4.3.6 Lamp Replacement

DANGER
• Lamp replacement must be performed by a qualified service technician only.
• EXPLOSION HAZARD! Wear authorized protective clothing (P/N: 598900-095) whenever
the internal lamp door is open and when handling the lamp.
• Never twist or bend the quartz lamp body.
• Use the correct wattage lamp supplied by Christie.
• Ensure those within the vicinity of the projector are also wearing protective safety gear.
• Never attempt to remove the lamp when it is hot. The lamp is under a great deal of pres-
sure when hot and may explode, causing personal injury or death and/or property damage.
Allow lamp to cool completely.
WARNING
1. Turn OFF Main AC: Click the Power OFF button,
and main AC OFF. Allow the internal cooling fans to run for at least 10 minutes to cool the lamp.
2. Unplug the Projector: When the cooling fans stop, unplug the projector. Always power down and unplug
the projector prior to servicing. Allow the lamp to cool before handling.
3. Open the Lamp Door: Wearing authorized protective safety gear, unlock and open the lamp door. If
desired, release the latch mechanism to remove the door entirely.
4. Remove the old lamp and inspect the reflector.
a. Remove the two captive screws securing the isolator (5./C).
a. Using a 5mm hex key (provided on lamp door), remove the screw securing the anode wire. (5./D).
b. Loosen the cathode screw (5./E) using the hex key, provided on the rear access nut (5./F).
c. Holding the lamp from the anode end, carefully unscrew and remove the cathode nut (5./F).
d. Hold the lamp from the anode end and carefully slide out ensuring not to make contact with the
reflector.
e. With your free hand guide the cathode end out of the reflector, on an angle.
f. Before placing the old lamp into its protective case ensure the cathode nut is reinstalled. Place the
lamp, within its case, on the floor where it cannot fall or be bumped. WARNING! Handle box with
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)
Improper installation of the lamp can cause serious damage to the projector.
Section 4: Maintenance
, on the TPC Main panel to turn the lamp
4-5