Ac/Power Precautions; Power Cords And Attachments; Lamp Precautions; Wear Protective Clothing - Christie Solaria CP2210 Setup Manual

1.2.3 AC/Power Precautions

WARNING
1) Use only the AC power cord supplied. DO NOT attempt operation if the AC supply is not
within the specified voltage and power range. For details, refer to Section 6 - Specifications
from the CP2210 User Manual (020-100410-xx).
2) As a safety feature the projector is equipped with a three-wire plug with a third
(grounding) pin. If you are unable to insert the plug into the outlet, contact an electrician to
have the outlet replaced. DO NOT defeat the safety purpose of the grounding-type plug.
3) DO NOT attempt operation if the AC supply is not within the rated voltage range, as
specified on the licence label.
4) Disconnect projector from AC before opening any enclosure.
1) DO NOT allow anything to rest on the power cord. Locate the projector where the cord
cannot be abused by persons walking on it or objects rolling over it. Never operate the
projector if the power cable appears damaged in any way.
2) DO NOT overload power outlets and extension cords as this can result in fire or shock
hazards.
3) Note that only qualified service technicians are permitted to open any enclosure on the
product and only if the AC has been fully disconnected from the product.

Power Cords and Attachments

WARNING
that you are using a line cord, socket and power plug that meets the appropriate local rating
standards. 2) Use only an AC power cord recommended by Christie. Do not attempt
operation if the AC supply and cord are not within the specified voltage and power range.
Use only the attachments and/or accessories recommended by Christie. Use of others may result in the risk of
fire, shock or personal injury.

1.2.4 Lamp Precautions

DANGER
lamp door is open! Never attempt to remove the lamp directly after use. The lamp is under
significant pressure when hot and cold, and may explode, causing personal injury and/or
property damage.
Any lamp used in the CP2210 is under high pressure and must be handled with great care at all times. Lamps
may explode if dropped or mishandled.

Wear Protective Clothing

Never open the lamp door unless you are wearing authorized protective clothing such as that included in a
Christie Protective Clothing Safety Kit (P/N: 598900-095). Recommended protective clothing includes, but
may not be limited to a polycarbonate face shield, protective gloves, and a quilted ballistic nylon jacket or a
welder's jacket. NOTE: Christie's protective clothing recommendations are subject to change. Any local or
federal specifications take precedence over Christie recommendations.
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)
1) The North American rated line cord is provided with each projector. Ensure
EXPLOSION HAZARD! Wear authorized protective safety gear whenever the
Section 1: Introduction
1-3