Maintenance And Cleaning; Lamp; Optical; Optical Component Cleaning Supplies - Christie Solaria CP2210 Setup Manual

4.3

Maintenance and Cleaning

DANGER
proper protective clothing is worn during maintenance.
To help ensure optimized performance and reliability, regularly check electrical, optical and other components
as described below.

4.3.1 Lamp

Check: Every 60 days or 500 hours
DANGER
• Check the contact surfaces of anode (positive) and cathode (negative) connections for cleanliness.
• Clean electrical contact surfaces as necessary to prevent contact resistance from scorching connectors. Use
appropriate contact cleaner.
• Verify that all electrical and lamp connections are tight.

4.3.2 Optical

Unnecessary cleaning of optics can be more harmful than helpful, increasing the risk of degrading delicate
coatings and surfaces. In this projector, check only the lens and lamp reflector. Maintenance of other optical
components requires a qualified service technician. Check these components periodically in a clean, dust-free
environment using a high-intensity light source or flashlight. Clean them only when dust, dirt, oil, fingerprints
or other marks are obvious. Never touch an optical surface with your bare hands. Always wear latex lab
gloves.

Optical Component Cleaning Supplies

• Soft camel-hair brush
• Dust-free blower - filtered dry nitrogen blown through an anti-static nozzle
• Dust-free lens tissue such as Melles Griot Kodak tissues (18LAB020), Optowipes (18LAB022), Kim Wipes
or equivalent
• For lens only. Lens cleaning solution such as Melles Griot Optics Cleaning Fluid 18LAB011 or equivalent
• For reflector only. Methanol
• Cotton swabs with wooden stems only
• Lens cleaning cloth/microfibre such as Melles Griot 18LAB024 or equivalent
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)
Electrical Shock Hazard! Disconnect from AC when servicing. Ensure the
Always disconnect from AC and wear authorized protective safety gear.
Section 4: Maintenance
4-3