Step 6: Install Lens; Primary Zoom Lens Installation - Christie Solaria CP2210 Setup Manual

2.3.5 Step 6: Install Lens

the main front electronics. It is important a projector never be operated without a lens
installed.

Primary Zoom Lens Installation

1. Turn the lens clamp to the OPEN position
(Figure 2-6).
2. Remove the two hex screws from the lens mount
(Figure 2-7).
3. Orient the lens so the lens retaining ring mounts line
up with the lens mount. Fully insert the assembly
straight into the lens mount opening without turning.
(Figure 2-6). Magnets, mounted inside the lens
mount, help to properly guide the lens. When you hear
a clicking sound it indicates the lens has made contact
with the magnets. These magnetic guides ensure the
lens is properly seated inside the mount, that the
aperture is orientated correctly and that the connector
for motorized zoom and focus is properly connected.
4. Secure the two hex screws and position the lens clamp
DOWN to lock the lens assembly in place (Figure 2-7).
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)
The lens seals the projector, preventing contaminants from entering the area of
Figure 2-7 Lock Lens in Place
Section 2: Installation and Setup
Figure 2-6 Insert Lens
2-5