Calibrate The Ils; Tpc; Ethernet; Trouble Establishing Communication With Projector - Christie Solaria CP2210 Setup Manual

Section 5: Troubleshooting

5.3.2 Calibrate the ILS

The ILS must be calibrated when:
• a new lens has been installed
To calibrate the ILS, click the
Enable Automatic ILS
5.4

TPC

1. If the TPC fails to initialize, re-boot the projector.
2. A failed TPC usually indicates a system failure requiring service.
3. If the TPC display is blank, ensure the TPC is on by opening the flap at the back of the TPC and verify the
grey button in the bottom left corner is ON.
4. If the locations of button presses on the screen seem to be misinterpreted, the TPC screen may need
recalibrating. In the Administrator Setup: Preferences window, click the
follow the onscreen instructions.
5.5

Ethernet

5.5.1 Trouble Establishing Communication with Projector

Ensure Ethernet settings are valid for the site. All devices should have the same subnet mask yet unique IP
addresses.
5.6

Displays

Some of the following troubleshooting entries assume the use of a third-party input source for displaying
alternative "non-cinema" material. Before proceeding, ensure to consult the documentation supplied with the
external equipment.

5.6.1 Blank Screen, No Display of Cinema Image

1. Ensure the lens cap is not on either end of the lens.
2. Ensure the lamp is ON.
3. Confirm all power connections are still OK.
4. Ensure the douser is OPEN by verifying the state of the douser on Main panel.
5. Ensure any test pattern other than the full black test pattern displays properly.
6. Is the correct display file selected?
7. Is the correct cinema port connected for this display file (i.e., 292-A or 292-B)? Check connections.
5-4
Full Calibration
is NOT selected, the lens will return to the remembered setting.
button. NOTE: If the
Full Calibration
button is selected when
button and
Calibrate Screen
CP2210 Setup Guide
020-100524-02 Rev. 1 (11-2010)