Connecting For Communications; Pc/Laptop, Server Or Network - Christie Solaria CP2210 Setup Manual

Solaria series

Hide thumbs Also See for Solaria CP2210:

Table of Contents

2.4.2 Connecting for Communications

protocol and is intended for Christie accessories or automation controllers only. DO NOT

connect other devices here.

Many communications with the projector are initiated on the Touch Panel Controller (TPC), which is mounted

at the rear of the projector. Depending on the installation, you may also need certain other serial and/or

Ethernet links to the CP2210, such as from a server or PC functioning as a controller, or from an existing on-

site network including other equipment. For applications or equipment utilizing serial communications, use the

Christie-proprietary serial protocol to connect to the RS232 PIB port on the PIB. When using Christie serial

protocol over Ethernet connect to port 5000.

To communicate with the projector from a computer, server or an existing network, connect the equipment to

the Ethernet hub or switch at your site.

CP2210 Setup Guide

020-100524-02 Rev. 1 (11-2010)

The RS232 PIB port located on the PIB faceplate utilizes Christie-proprietary

Figure 2-13 Connecting Communications

Section 2: Installation and Setup

2-11

Table of Contents