Iwatsu Omega-Phone 924 Technical Manual page 102

Omega-Phone 924 Technical Manual
Programming System Speed Dial:
1. To enter a CO Line Flash ("hook-flash") in a System Speed number, press Fea-
ture 3. The stored "hook-flash" is indicated by a "/" character at telephones with
displays. For example to enter "FLASH 1389" in a system speed number the entry
would be: "Feature + 1389". The displayed system speed number would be "/
1389".
2. To enter a "Pause" in a System Speed Dial, press Feature 70. A stored pause is
indicated by a "P" character. For example to enter "9P0110118888635773141"
into a system speed number the entry would be "9 + Feature 70 +
001188635773141. The displayed system speed number would be
"9P01188635773141".
3. To chain one speed dial number to another, press Feature 1 the speed dial number
location to dial. For example; if a very long telephone number will not fit into one
speed number location, split the number into two locations. To store the number
"12345678901234567890", for example, into locations 20 and 21:
• Enter into location 20: "1234567890Feature 1 21".
• Enter into 21: "1234567890"
• Dial this sequence of numbers by accessing only Speed bin location "20."
• A maximum of 16 digits can be entered into any one speed bin.
Service Mode Switching:
The system can run in one of three modes, Day, Night and Timed. Only the
programmed attendant position has the ability to manually change the system from
Day to Night, or Night to Day. Once the system is manually placed in either mode, it
will remain in that mode until the attendant changes the mode. However, if in timed
mode, the system will switch from Day to Night Mode automatically.
The Attendant extension must dial Feature 63 Plus the Attendant Extension Password
to switch from Day to Night or Night to Day.
Associated Features
Do Not Disturb
Attendant Administration (Feature #00):
Service Mode Change
Auto Attendant Message Record/Review
Temporary Service Mode
(Abbr.) System Speed Dial
Call Forward Auxiliary Lamp
Conditions:
1. The extension User Password programmed for the Attendant extension is required
for entry into Attendant Administration, Caller ID Table and Ring Mode
2. Only the designated Attendant extension can manually change the system Ring
Mode.
3. The Attendant extension receives all calls via any extension that invokes Forced
Intercom Call Forward.
98
Associated Programming
Resource:
Attendant 4-03
Attendant Alternate 4-04
User Password 4-09