Module Installation - Iwatsu Omega-Phone 924 Technical Manual

Chapter 4

Module Installation

OM-308 (3 x 8) Expansion Module
1. Remove the KSU cover.
2. Locate the pin connector socket labeled: FOR E308E/B.
3. Locate the four brass-colored stand-off posts on the motherboard (near the E308
connector).
4. Place the module on top of the stand-off posts and align the pre-drilled holes on
the module with the stand-off posts.
5. Before securing the module, plug the ribbon cable into the pin connector socket
labeled: FOR E08E/B.
6. Use the screws (provided) to secure the module to the stand-off posts.
7. Replace the cover and power up the system.
Installation
23