G Sensor Menu Section; Ptz Section; Dvr Id Section - AngelTrax Hybrid Quest MDVR Quick Setup Manual

Sub Menu (Cont.)
G Sensor (Optional Feature)
1. G Value is the value assigned to impact force. The G Sensor
Axis Switch on back of the Hybrid Quest™ allows you to
select G1 or G2 options. Refer to Number 8 on the Hybrid
Quest™ Connections, Ports and Controls Diagram, page
14, for further detail.
• G1 = X Value (measures front to back impact ONLY).
• G2 = Y Value (measures side to side impact), Z Value
(measures impact up and down) and X Value, as
described above.
After using the G Sensor Axis Switch (number 8 on the
2.
Hybrid Quest™ Connections, Ports and Controls Diagram,
page 14) to select G1 or G2, use the arrow buttons on
the remote to select the G Sensor feature from the Sub
Menu (see Figure 5). At the G Sensor feature, press the plus
button on the remote to change the setting to G1 or G2 and
press Enter. To use the AngelTrax GFORCE-2 three (3) axis
G-Force sensor, the Hybrid Quest™ MUST BE set to the
G2 setting.
3. The G Sensor menu has three options when the G2 option
is selected: X Value, Y Value and Z Value. Each value may
be adjusted using the plus button on the remote (0.5 to 2.5
- see Figure 6). The higher the number selected, the greater
the impact registered. A notification marker will be made on
the hard drive for any force registered over your
selected value.
To save your changes and return to the Sub Menu, press the
4.
Menu button on the remote.
PTZ
THIS FEATURE IS NOT USED IN THE TRANSPORTATION/
MOBILE INDUSTRY .
DVR ID
Refer to the Vehicle ID Type and Number Section, page 25, for
further information.
AngelTrax | 53
NOTICE - G SENSOR SETTINGS:
To use the AngelTrax GFORCE-2 three (3) axis G-Force
sensor, the Hybrid Quest™ MUST BE set to the G2
setting, both in the on-screen menu and with the
G Sensor Axis Switch on the back of the DVR.
5
6