Driver Action-Detecting Per Vehicle Table - AngelTrax Hybrid Quest MDVR Quick Setup Manual

Hybrid Quest™ Connections/Ports (Cont.)
8. G-FORCE RECEIVER (Optional Feature)
• Connect the G-Force sensor to this port.
• Detects changes in G-Force such as sudden stops
or collisions.
9. "TO GPS" CONNECTION (Optional Feature)
• Connect the GPS antenna to this port
10. PANIC BUTTON CONNECTION
• The external signal button (or "PANIC" button), can be
connected to show DVR status without using a video
monitor. This button has the following functions:
a. Power indicator LED
b. Record indicator LED
c. GPS signal indicator LED
d. 'PANIC' button for emergencies
11. ETHERNET INPUT ("LAN CONNECTION")
• Ethernet port with RJ-45 connector for connecting to the
LAN router
12. POWER CONNECTION
• Connects the key on the connection wire (yellow), to
vehicle ignition ON position
• Plugs the power cord to the battery (red)
• Connects to the common vehicle ground (black)
• Backup relay switch for 7-inch monitors (blue)
Driver Action-detecting per Vehicle Configuration
School Bus and Taxi Transit Bus
AL - Amber lights ON HL - Headlights
BR - Brake ON PB - Parking Brake
BU - Back Up or Reverse BU - Back Up or Reverse
SA - Stop arm extended SB - Service Brake
RT - Right Turn RT - Right Turn
LT - Left Turn LT - Left Turn
D:1 - Door 1 D:1 - Door 1
D:2 - Door 2 D:2 - Door 2
PANIC PANIC
AngelTrax | 15
13. DRIVER ACTION-DETECTING WIRE CONNECTION
• Sensor record cable connection has eight (8) wires:
a.
b.
c.
d.
e.
f.
g.
h.
See the Driver Action-Detecting per Vehicle
•
Configuration table below for details on each wire's
function on different types of vehicles
14. WIRELESS DONGLE CONNECTION
• Used to power the Wireless Bridge
15. GSM ROUTER CONNECTION
• Used as a Cradle Point for the GMS router.
• Cradle Point uses a GSM card (air card)
• A Cradle Point creates faster connections/does
not disconnect
16. REMOTE ACCESS RECEIVER
• Serial port for future notification devices
Train Police
HR - Horn EL - Emergency Light
BR - Brake ON BR - Brake ON
BU - Back Up or Reverse SI - Siren Indicator
BL - Bell PK - Parking
FW - Forward RT - Right Turn
EM - Emergency LT - Left Turn
D:1 - Not used DR - Door Open
MR - Microphone
D:2 - Not used
Reception
PANIC PANIC
AL - Amber lights ON (gray wire)
BR - Brake ON (red wire)
BU - Reverse (blue wire)
SA - Stop arm extended (white wire)
RT - Right turn (green wire)
LT - Left turn (yellow wire)
D:1 - Door 1 (purple wire)
D:2 - Door 2 (orange wire)
Truck (Future
Application)
HL - Headlights
BR - Brake ON
BU - Back Up or Reverse
SB - Service Brake
RT - Right Turn
LT - Left Turn
PE2 - Panic Event 2
PE3 - Panic Event 3
PE1 - Panic Event 1