AngelTrax Hybrid Quest MDVR Quick Setup Manual page 27

On-Screen Display Diagram (Cont.)
Indicator Features
8 Door Signal
9 Voltage Display
10 Date and Time
11 Record Status
12 Record Mode
13 Heading (Available
only with the use of
GPS-E1 antenna)
14 Speed (Available
only with use of
GPS-E1 antenna)
15 GPS Coordinates
(Available only with
use of GPS-E1
antenna)
16 SD Record Module
17 Other Signals
AngelTrax | 20
Description
D:-- The number one or two will display when the door is open. There are two door signals,
typically one for the front and one for the back. If both doors are open, D:12 will display. If
there are no signal wires connected with the doors, D:-- will continue to display. The door
signal is marked on the hard drive, and will display in playback.
Shows the amount of voltage input to the DVR.
Current or recorded date and time. Date and time can be automatically updated using
GPS technology. Automatic date/time update is only available if used in combination with
a GPS-E1 antenna.
A red dot will be visible if the unit is recording. The dot will not be visible if the unit is not
recording. The area between the date/time display and Record Mode will show the DVR
status. If a camera connection is lost, a 'LOSS' message will display.
CON = Continuous record. Continuous record is the default setting. To change the record
mode, select Record Setup > Record Mode. See Record Setup Section, page 35.
H: - Shows heading direction (North, South, East or West).
0MPH displays the miles per hour the vehicle is currently traveling.
If a GPS-E1 antenna is installed, the vehicle's latitude and longitude is displayed on the
local monitor. When your recorded video data is reviewed with AngelTrax playback software,
each channel is marked with your vehicle's tracking information.
SD will be displayed if the SD Record Module feature is turned ON.
TL: Turn left displays on local monitor and in playback (flashes).
TR: Turn right displays on local monitor and in playback (flashes).
BR: Brake displays on local monitor and in playback.
AL: Amber lights display on local monitor and in playback (flashes).
SA: Stop arm displays on local monitor and in playback. The SA signal switches from
VSM™ to camera three in applications where four cameras and VSM™ is required, and
also in applications that require eight cameras and VSM™.
BU: Back up/reverse displays on local monitor and in playback.
SB: Service brake
PB: Parking brake
HL: Headlights
HR: Horn
BL: Bell
FW: Forward
EM: Emergency