Formatting The Hdd Section - AngelTrax Hybrid Quest MDVR Quick Setup Manual

Formating the Hard Drive
INSERTING A HARD DRIVE FROM ANOTHER DVR INTO THE
HYBRID QUEST™ WILL AUTOMATICALLY FORMAT THE DRIVE,
ERASING ALL RECORDED DATA THAT THE HARD DRIVE
CONTAINS. PLEASE BE SURE TO BACK UP ANY SENSITIVE
MATERIAL STORED ON A HARD DRIVE BEFORE INSERTING IT
INTO THE HYBRID QUEST™.
1. To format the hard drive, use the arrow buttons on the
remote to select HDD Setup from the Main Menu (see
Figure 1), and press ENTER.
From the Hard Disk Setup menu, use the arrow buttons to
2.
select HDD Format (see Figure 2), and press ENTER.
3. At the HDD Format menu, select the hard drive number
you want to format (see Figure 3) and select ENTER. As the
Hybrid Quest™ MDVR has only one hard drive, leave the
Select HDD option setting set to 1.
NOTICE: Attempting to format a hard drive that is not
connected to the DVR (i.e. attempting to format HDD 2
on the Hybrid Quest™ DVR) will produce a NO DEVICE
message at the bottom of the HDD Format menu.
4. Use the arrow buttons on the remote to navigate to the
Format option (see Figure 3). Use the plus button on the
remote to select Yes, and press ENTER.
At the bottom of the HDD Format screen, a message will
5.
appear to show that formatting is in progress (see Figure 4).
After the hard drive is formatted, a Format OK message will
appear at the bottom of the Format screen (see Figure 4).
The hard drive is now reset and enabled for recording.
6. The system will return to live camera view, and record mode.
AngelTrax | 26
1
2
3
4