Table of Contents
Advertisement
Replacing the Main Board
1.
Using the keys supplied, remove the front cover from the
Hybrid Quest™ by turning the medium-sized key (905)
clockwise (see Figure 5).
2.
With the supplied Allen screwdriver, remove the two screws
on either side of the Hybrid Quest's™ main board
(see Figure 6).
Place the supplied board removal tool (see the Parts List
3.
(Accessory Box), page 3) under the two notches in front
of the main board, and push down with removal tool to pop
the board out (see Figure 7).
4.
Remove the old main board.
5.
Retrieve the new main board from the box. Slide the main
board into the top slot in the front of the Hybrid Quest™,
until you hear a 'snap.'
6.
With the supplied Allen screwdriver, replace the two screws
on either side of the Hybrid Quest's™ main board.
7.
If your new main board has a lock, use the smallest key
provided (1102) to lock the main board in by turning the
main board key lock clockwise until the notch is in the
'down' position (see Figure 8).
8.
Replace the front cover, aligning the tabs on the bottom
of the door with the notches on the bottom of the Hybrid
Quest™. Insert the medium-sized key provided (905), and
push the top of the door closed. Turn the key counter-
clockwise to lock the door.
AngelTrax | 64
Modular
Hybrid
Component
MDVR
Push out the Main Board
SD Card Slot
Remote
A/V
Host
Rec. SD
Output
Rec. 1
Rec. 2
Main Board
GPS
PWR
12V DC
Reset
Output
Power Supply
Reset
PWR
Link
5
6
7
Push down the
Board Removal Tool
8
Slave
Hide quick links:
Advertisement
Table of Contents
