Using The Hybrid Quest™ Menu Section - AngelTrax Hybrid Quest MDVR Quick Setup Manual

Using the Hybrid Quest™ Menu
Hybrid Quest™ DVRs are equipped with a user menu section designed for the customization of your system. However, there are a few
settings that must be set for the MDVR to function properly, including: Date and Time, Vehicle I.D., Vehicle I.D. Number and Formatting
the Hard Drive.
To begin setup of your DVR, follow the user guide
referenced below:
1. Power up the DVR by turning on the vehicle's ignition.
2. Remove the plastic insert in the battery compartment of the
supplied DVR remote.
3. Connect your portable monitor to the composite A/V output
on the front of the DVR using the supplied cables (see
Figure 1).
4. You should now see a live view of your cameras. Please
refer to the On-Screen Display Diagram, page 19, for an
explanation of live camera view features (see Figure 2).
AngelTrax | 21
A/V Output on MDVR
SD Card Slot
Remote
A/V Host Slave
Rec. SD
Output
Rec. 1
Rec. 2
Main Board
GPS PWR
12V DC
Reset
Output
Power Supply
Reset
PWR Link
1
A/V Opening on Door
2