Notification Section; Ch3 Video Loss Event Section - AngelTrax Hybrid Quest MDVR Quick Setup Manual

Sub Menu (Cont.)
Notification (Optional Feature)
1. From the Sub Menu, use the arrow buttons to navigate to
the Notification feature (see Figure 16), and press Enter.
Under the Notification Setup menu, the Notification may
2.
be switched from Zonar to Tracker by pressing the plus or
minus buttons on the remote (see Figure 17).
CH3 Video Loss Event
1. The CH3 Video Loss Event feature should be turned ON if
the vehicle stop arm activation switch (located on the back
of the Hybrid Quest™ — refer to Number 3 on the Hybrid
Quest™ Connections, Ports and Controls Diagram, page
14) is being utilized, and OFF if it is not.
ON = Beep (Video Loss Alert). The switch on the VSM™
2.
module should be set on CAM3 or VSM™.
3. OFF = Terminates Beep (Video Loss Alert) for Camera 3. The
switch on the VSM™ module should be set on Auto.
AngelTrax | 58
17
18
19