AngelTrax Hybrid Quest MDVR Quick Setup Manual page 18

6. Connect the power cable to the power source, then connect
the power cable and ignition to the MDVR (see Figure 5).
Power-up the MDVR by turning on the vehicle's ignition.
CAUTION - POWER CONNECTION:
Ensure the connection to the power source is secure,
and then connect the cables to the rear of the DVR.
7. Ensure the Hybrid Quest™ powers-up and goes into REC
(Record) mode, indicated by the flickering amber light on
the front of the unit and — if connected — on the panic
event button (see Figure 6). Depending on which medium
the DVR is currently recording to (SD card or HDD 1), the
flickering amber light on the front of the unit will be the Rec.
SD or Rec. 1 light. If the unit fails to go into REC mode,
make sure the hard drive is in the 'lock' position.
8. Power-down the unit by turning off the ignition and
disconnect the power cables.
9. Connect all signal and camera cables to the back of the unit
and reconnect the power cables to the unit.
10. When everything is working properly, attach the back cover
around the cables and onto the back of the unit (see
Figure 7). Lock the back cover with the largest key provided.
11. Power-up the Hybrid Quest™ by turning on the
vehicle's ignition.
12. Connect the local monitor to the Hybrid Quest™, either
without the front cover, or through the A/V output opening in
the front cover (see Figure 8).
13. Check camera angles, signal inputs and test audio.
14. Remove the plastic insert in the battery compartment of the
supplied Hybrid Quest™ MDVR remote. Select Menu located
in the top left corner of the remote (see Figure 9), to set the
correct time (Refer to the Date/Time Setup Section, page
22, for detailed instructions).
15. Turn the vehicle ignition off and confirm the shut down
delay is working properly.
AngelTrax | 11
SD Card Slot
Remote
A/V Host Slave
Rec. SD
Output
Rec. 1
Rec. 2
Main Board
GPS
PWR
12V DC
Reset
Output
Power Supply
Reset
PWR Link
LAN
®
A/V Output on MDVR
SD Card Slot
Remote
A/V Host Slave
Rec. SD
Output
Rec. 1
Rec. 2
Main Board
GPS PWR
12V DC
Reset
Output
Power Supply
Reset
PWR Link
MENU ZOOM
ENTER
REWIND PLAY PAUSE
AUDIO POP
5
6
Record indicator light
flickers in REC mode
{ Panic Button }
7
8
A/V Opening on Door
9
SEQUENCE
COPY
STOP
QUAD