Power Supply Using A Switch - Mobotix D26 Dome Manual

D26 Camera Manual: Installation
IP addresses in the figure are
shown only as an example
For the D26 you should use
the blue MX-NPA-PoE-Set
or the MX-NPA-Box – pre-
vious MOBOTIX network
power accessories, such
as the NPA-Set, Power-
Box and Power-Rack
(MX-NPA-Set, MX-NPR-4
and MX-NPR8/20) are not
suitable for use with the D26
66
Connecting the Patch Cable to an MX-Overvoltage-Protection-Box, an MX-NPA-Box or a
Standard Network Outlet
To establish the network connection of the camera using an
MX-Overvoltage-Protection-Box or an MX-NPA-Box, remove the
blue bayonet catch and the blue sealing plug from the right-hand
side of the box. Insert the MOBOTIX patch cable into the box
and fasten the cable using the blue bayonet catch.
For additional‚ information on how to install an
MX-Overvoltage-Protection-Box or an MX-NPA-Box , open
www.mobotix.com and see the Online Catalog under
Accessories > System Components > Interface Boxes.
When using a standard network outlet (only for indoor installations), insert the MOBOTIX
patch cable of the D26 directly into the network outlet.
If additional cables are required inside the housing, they must be connected as described in
Section 2.8.6, «Connecting a USB Cable» and Section 2.8.7, «Connecting a Two-Wire MxBus Cable».

2.9.3 Power Supply Using a Switch

1. Connect the factory pre-installed cable of the camera to the camera connector of
the PoE adapter.
2. Connect the LAN/Power connector of the PoE adapter to the Ethernet connector of
the switch/router or the Ethernet port.
3. Plug the RJ45 connector of the power supply unit into the PC/Power connector of
the PoE adapter.
Switch/router
LAN/www
PoE adapter
(MX-NPA-PoE)
Camera
RJ45
PC
(10.8.0.11/255.0.0.0)
Power supply
Camera
(10.8.0.99)
Patch cable