Use Multifunction Button As Ptt Button; Messaging Settings - ASCOM d62 Talker Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
(alarm on long press). The corresponding settings can also be configured for the push-
button when it is pressed twice or more (alarm on multiple press).
Example of configuration:
1 Select Alarm > Common
2 In the Number for automatic call after alarm field, enter the number to be dialed.
3 Select Alarm > Alarm on long press
4 In the Alarm type for long press drop-down list, select "Not used".
5 In the Mode for automatic call after alarm drop-down list, select one of the following:
- Normal: the call is established as an ordinary call.
- Loudspeaking: the loudspeaker on the backside of the handset is turned on.
- Monitoring: a one-way speech channel is established, that is, the called part can only
listen to an conversation.
This configuration lets the user long press the push-button to dial the number without
sending an alarm. However, the push-button can be configured to send an alarm by pressing
it twice (see Alarm type for multiple press in chapter
34).
Information about the handset location can also be sent along with an alarm, see
Station Positioning

5.26 Use Multifunction Button as PTT Button

Note: This feature can only be configured in the d62 Messenger.
The handset mute button is normally used to switch to talk mode during a PTT call.
However, the Multifunction button may also be configured to do this, and in so doing,
provide the user with an additional means of switching to talk mode.
NOTE: If the multifunction button is enabled for PTT, it can no longer be configured in the
handset menu to provide shortcuts to handset functions. Any existing shortcuts that have
been configured are disabled, both for long and multiple presses of the multifunction
button. Shortcuts are also disabled when the handset is in idle mode.
To configure the multifunction button as a PTT button, perform the following steps:
1 In the PDM, select the parameter Push to Talk > Use multifunction button for PTT
2 Set the value of the parameter to "On".

5.27 Messaging Settings

NOTE: This feature is applicable for d62 Messenger and d62 Protector only.
The way incoming messages are indicated and displayed in handset can be configured. The
parameters can be found at:
Settings > Sound and Alerts
• Vibrating alert
Determines if the handset vibrates when receiving incoming calls and messages.
• Message alert
Determines the message sound for incoming messages. A predefined melody (Message
1 - Message 7) or a beep code that represents a certain sound can be selected. For more
31 October 2013 / Ver. J
on page 31 and 5.20 DECT Location
5.24 Common Alarm Settings
on page 32.
TD 92639EN
on page
5.19 Base
36