Replacement Procedure Choice Guide; Replacement Of Handset With The Device Manager; Data Included In A Replacement Transfer - ASCOM d62 Talker Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
4.6

Replacement Procedure Choice Guide

Depending on situation, two different replacement procedures can be chosen; replacement
via PDM/Device Manager and Easy Replacement. Use the following list as a guide to choose
which procedure to use.
• If a handset needs to be replaced due to for example a broken display, see the User
Manual for Ascom d62 DECT Handset.
• If the electrical connection is damaged, the Easy Replacement procedure may not work.
Depending on fault, a replacement might work via PDM/Device Manager, see

Replacement of Handset with the Device Manager

Replacement with PDM
• If two handsets and their settings are to be switched between two users, follow
Replacement of Handset with the Device Manager
Replacement with PDM
4.7 Replacement of Handset with the Device Manager
Both the old handset and the new handset must be of the same device type, that is, d62.
The same extension number is assigned to the new handset.
Make sure that the old handset is saved in the Device Manager. Start the Device Manager
and navigate to the "Numbers" tab. There shall be a tick in the "Saved" column for the old
handset.
If the handset is not saved, insert it into a desktop charger or rack charger connected to
Device Manager and perform a save. For additional information, see the Installation and
Operation Manual for the Unite module being used.
If the old handset settings cannot be saved, stop this replacement procedure. Instead
unsubscribe the old handset from the PBX, register the new handset and follow the
instructions for installing a handset, see
When the handset is saved, unsubscribe the old handset from the PBX.
The following steps are described in two different scenarios, check which one suits the best
before proceeding.
4.7.1

Data Included in a Replacement Transfer

The following data is replaced during a replacement with Device Manager:
• User parameters (including User ID)
• Contacts (entered by the user)
Note that the following data is not replaced:
• DECT registration
• Call list
• Messages
• Bluetooth pairing list
• Company phonebook
• Downloaded Language
• Licenses
1. A handset product license (for example, d62 Messenger) and feature license(s) can be moved using the Move license
function in the Device Manager.
31 October 2013 / Ver. J
on page 15.
on page 15.
1
on page 14 or
on page 14 or
3.2 Installing a New Handset
TD 92639EN
4.7
4.8 Handset
4.7
4.8 Handset
on page 8.
14