Use Multifunction Button As Ptt Button; Answering Settings - ASCOM d83 Manual

CONFIGURATION MANUAL
Ascom d83 DECT Handset
• No-movement detection time
Determines when the warning phase starts after No-movement alarm is triggered.
• Warning phase duration
Determines the time before the warning phase is ended and the alarm is sent.
• Delay of no-movement and man-down alarm enabled
Determines if detection time for man-down and no-movement alarms are extended.
• Time of user delay of no-movement and man-down
Determines how long time the extended detection time is for man-down and no-movement alarms.
• ALS
• Mode for automatic call after alarm
The call can be established in the following modes:
− Off: No automatic call after alarm.
− Normal: the call is established as an ordinary call.
− Loudspeaking: the loudspeaker on the backside of the handset is turned on.
− Monitoring: a one-way speech channel is established, that is, the called part can only listen to an
conversation.
• Turn off NM-MD during call
Determines if the Man-down alarm and No-movement alarm is disabled during a call.
See also 5.27 Common Alarm Settings, page 37
Information about the handset location can also be sent along with an alarm, see
28, 5.21 DECT Location, page

5.31 Use Multifunction Button as PTT Button

Ascom d83 Handset has two multifunction buttons called Multifunction Button 1, located on the left side,
and Multifunction Button 2, located on the right side when looking at the screen.
This feature can only be configured in Messenger and Protector handsets only for Multifunction
Button 2.
If the Multifunction Button 2 is enabled for PTT, it can no longer be configured in the handset
menu to provide shortcuts to handset functions. Any existing shortcuts that have been configured
are disabled, both for long and multiple presses of the multifunction button. Shortcuts are also
disabled when the handset is in idle mode.
The handset Multifunction Button 1 can be used by default to switch to talk mode during a PTT call.
However, the Multifunction Button 2 may also be configured to do this, and in doing so, provide the user
with an additional way to switch to talk mode.
To configure the Multifunction Button 2 as a PTT button, perform the following steps:
1. In the WinPDM, select the parameter Push to Talk → Use multifunction button for PTT.
2. Set the value of the parameter to On.

5.32 Answering Settings

Automatic answer is disabled when the device is PIN-locked.
TD 93426EN / 28 January 2022 / Ver. C
for additional parameter settings.
30, 5.22 IR Location, page 32
5.20 BLE Location, page
and 5.23 LF Location, page
Handset Configuration
35.
41