ASCOM d62 Talker Configuration Manual page 42

Configuration Manual
Ascom d62 DECT Handset
information on how to configure sounds with beep codes, see
Alerts with Beep Codes
• Message alert during call
Determines if a message alert should be played when receiving a message during a call.
• Message volume
Determines the message volume for incoming messages. By default, the message
volume is the same as the volume of the ring signal. A different message volume can be
set with this parameter. The parameter may also be set to "Silent" to mute the message
volume completely.
• Vibrator for call waiting
Determines whether or not the handset vibrates when another call is received before the
user has finished servicing an ongoing call. If set to "Yes", the handset vibrates during
the ongoing call.
• Vibrator for message during call
Determines if the handset vibrates when receiving messages during an ongoing call. The
Vibrate alert parameter must also be enabled if the handset is set to vibrate when
receiving a message during the call.
Settings > Messaging
• Text size
Size of the message text when viewing and writing messages.
• Time to Read (TTR)
Determines if the user needs to close a message manually, or if the message closes
automatically when TTR expires. Regardless how a message is closed, it is removed from
the message queue and stored in the Messaging Inbox. TTR starts when a message is
displayed and keep running also when the message is placed in the messaging queue. If
a user presses any key when a message is displayed, the TTR is reset. See also
Example of TTR and TTP settings
• Time to Prioritize (TTP)
Determines how long messages keep their priority status. The TTP starts when a
message is displayed. If a user presses any when a message is displayed, the TTP is reset.
If receiving a message with higher priority than the displayed message, the message
with lower priority is placed in queue and its TTP is paused. When the TTP elapsed for a
message, it is put last in the queue. See also
page 40.
• Message list representation
Can be set to text or a number or name.
• Repeat message indication
This parameter enables or disables message indications. It determines whether a
message indication is repeated until confirmed by the user or not. The current repetition
rate is 7 seconds. If the message itself contains a repetition, it overrides this setting.
• IM (Interactive Messaging) option mode
This parameter is used for older applications and sets that three soft keys shall be placed
automatically, i.e. on soft keys or in an option menu (list).
31 October 2013 / Ver. J
on page 39.
on page 40.§
5.27.2 Example of TTR and TTP settings
TD 92639EN
5.27.1 Configure Message
5.27.2
on
37