Save A Handset Configuration As A Template; Synchronizing A Handset With Pdm; Voice Mail; Wildcard Characters In Voice Mail Number - ASCOM d62 Talker Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
5.1.3

Save a Handset Configuration as a Template

Handset settings can be saved as template. Note that this does not include contacts and
other personal data. The template only contains configuration data.
This template can be used as a backup to restore the configuration of the handset at a later
stage or as a template that can be applied to a number of handsets.
1 Open PDM or the Device Manager.
2 Open the Numbers tab and select the handset you want to save as a template.
3 Make a right-click and select "Use as a template...". Enter a descriptive name for the
template.
4 The Edit template window is opened. By default, all parameters are selected and are
saved when clicking "OK".
If one or more parameters should be excluded, remove them by clearing the checkbox
next to the parameter.
Some parameters are user specific. If it is decided to apply this type of template to
several handsets, it is recommended to exclude the following parameters:
• Owner ID - A text string displayed in idle mode. The parameter is located directly
under "Settings".
• Phone lock PIN code - The security code used to unlock the keypad. The parameter
is located under Settings > Locks.
5 Click "OK".
5.1.4

Synchronizing a Handset with PDM

After installing and saving a handset, the handset is synchronized each time it is connected
to the PDM. The synchronization transfers parameter changes between the handset and the
PDM and vice versa as follows:
• If a parameter has been changed in the handset, it is transferred to the PDM/Device
Manager.
• If a parameter has been changed in the PDM/Device Manager while the telephone was
disconnected, it is transferred to the handset.
If the same parameter has been changed in both the PDM/Device Manager and the handset,
the value in PDM/Device Manager is transferred to the handset.
5.2

Voice Mail

In some systems it is needed to assign the handset number of the Voice Mail service. The
parameter can be set specifically for each PBX subscription on the handset and is accessed
from Systems > System x > PBX Settings > Numbers. "System x" is replaced with the
subscription (System A - System H) that is configured.
5.2.1

Wildcard Characters in Voice Mail Number

When programming voice mail dial strings in PDM/Device Manager, a wildcard character, N,
can be used to represent the phone's extension number.
For example, a PBX uses voicemail numbers that are a combination of a base voice mail
number and the phone's extension number. If the base voice mail number is 2222 and the
extension number is 4455, the voicemail number is 22224455. Using the N wildcard
character this can be written as: 2222N.
31 October 2013 / Ver. J
TD 92639EN
19