Handset Replacement With Device Manager In Dect System; Handset Replacement With Pdm; Handset Replacement With Pdm In Dect System - ASCOM d62 Talker Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
4.7.2

Handset Replacement with Device Manager in DECT System

NOTE: The handset to be installed must not have any previous valid registrations. If it has a
valid registration, unsubscribe the handset.
1 Unsubscribe the old handset. If the unsubscribtion cannot be performed in the
handset, unsubscribe the handset via the DECT interface. See the corresponding IP-
DECT documentation.
2 Subscribe the new handset with the same extension number as the old handset. The
subscription procedure is described in User Manual, Ascom d62 DECT Handset,
TD 92477GB. During the subscription procedure, the handset User ID is automatically
set to be the same as the extension number.
Tip: The User ID can be viewed in the handset by navigating to the menu:
Admin menu > Device info > User ID.
3 Insert the handset into a desktop charger or rack charger connected to Device
Manager or use an IP-DECT over-the-air connection. Navigate to the Numbers tab in
the Device Manager.
The new handset now has the same User ID as the old handset. The new handset is
automatically synchronized and data and parameter settings are transferred from
the old handset.
The synchronization can take a while if the Contacts in the original handset contains
a large number of entries.
4.8

Handset Replacement with PDM

To see which data that is replaced during this process, see
Replacement Transfer
Both the old handset and the new handset must be of the same device type (d62). The
same extension number is assigned to the new handset.
The new handset should not be subscribed to the PBX yet.
1 Perform a factory reset, see
handset has been previously used.
2 Make sure that the handset is saved in the PDM. In the Numbers tab, a saved handset
has the symbol
"Save" to transfer the settings to the new handset later on.
Note: If the old handset settings cannot be saved, stop this replacement procedure. Instead
register the new handset and follow the instructions for installing a handset, see
Installing a New Handset
4.8.1

Handset Replacement with PDM in DECT System

NOTE: The handset to be installed must not have any previous valid registrations. If it has a
valid registration, unsubscribe the handset.
1 Unsubscribe the old handset. If the unsubscribtion cannot be performed in the
handset, unsubscribe the handset via the DECT interface. See the corresponding IP-
DECT documentation.
31 October 2013 / Ver. J
on page 14.
4.5 Perform a Factory Reset
in the Saved column. If not, right-click the handset and select
on page 8.
TD 92639EN
4.7.1 Data Included in a
on page 13, if the new
3.2
15