Getting Started With Configuration Of The D62 Handset; Pdm Windows Version; Device Manager In Ims3/Unite Cm - ASCOM d62 Talker Configuration Manual

Configuration Manual
Ascom d62 DECT Handset
2

Getting Started with Configuration of the d62 Handset

The d62 handset can be configured by inserting it into a DC4 desktop charger or CR3 rack
charger. The charger is connected via USB or ethernet to the PDM or the Device Manager.
For IP-DECT systems, the d62 can be configured over-the-air.
This chapter describes how to configure handsets in three different system setups:
• with PDM Windows Version
• with Device Manager via chargers
• with Device Manager over-the air
2.1

PDM Windows Version

PDM is run on a PC. The handset is configured via PDM as follows:
• Connect a DC4 desktop charger or a CR3 rack charger via USB to the computer running
PDM.
• Start PDM.
• Place the handset in this charger connected to PDM. The handset can either be turned off
or turned on when placing it in the charger. A handset that is turned off starts up
automatically and the battery charging symbol is displayed.
For instructions on how to use PDM, see Installation and Operation Manual, Portable Device
Manager (PDM), Windows Version, TD 92325EN.
Figure 1. Configuration of handsets via PDM
2.2

Device Manager in IMS3/Unite CM

The Device Manager in IMS3/Unite CM runs on an ELISE3 module.
For instructions on how to use the IMS3/Unite CM, see Installation and Operation Manual for
IMS3/Unite CM.
31 October 2013 / Ver. J
Figure 1.
TD 92639EN
5