Figure 37: Dx2010 Dip Switch Configuration; Figure 38: Dx2010 Status Led Location; Table 9: Dx2010 Address Settings; Table 10: Dx2010 Dip Switch Settings - Bosch DS7200V2-EXP Installation Manual

DS7200V2-EXP | Installation Guide | 2. System Installation
and Setup
2.6.9 DX2010 Addressing
Any time you change the address DIP
switches, cycle the power to the
module OFF and then ON for the
changes to take effect.
Use Table 9 to set the address jumpers for all
DX2010s connected to the control panel.
Shaded rows only apply to the DS7240V2.

Table 9: DX2010 Address Settings

Locatio Standard
n Sensor Loop*
1 to 8 Data Bus Addr
101
9 to 16 Data Bus Addr
102
17 to 24 Data Bus Addr
103
25 to 32 Data Bus Addr
104
33 to 40 Data Bus Addr
105
* For Standard Sensor Loop, set the location's
"Device" parameter to "2." Set the DX2010
address as shown in Table 10. See Location ##,
Device on page 82 for programming details.
** For Doubled Sensor Loop, set the location's
"Device" parameter to "3." Set the DX2010
address as shown in Table 10.
For tamper-wired zones, use Data Bus Addresses
101 to105. Set the device type settings to "2"
(see Location ##, Device on page 82).
Set the address DIP switches as shown in Table
10.
Shaded rows apply only to the DS7240V2.
Table 10: DX2010 DIP Switch Settings
DX2010 DIP Switch Settings
DIP S1 S2
Switche
s
Module 32 16
Address
101 OFF OFF
102 OFF OFF
103 OFF OFF
104 OFF OFF
105 OFF OFF
106 OFF OFF
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
Doubled
Sensor Loop**
Data Bus Addr
106
Data Bus Addr
106
Data Bus Addr
107
Data Bus Addr
107
S3 S4 S5 S6
8 4 2 1
OFF OFF OFF OFF
OFF OFF OFF ON
OFF OFF ON OFF
OFF OFF ON ON
OFF ON OFF OFF
OFF ON OFF ON
107 OFF OFF
See Figure 37 for proper DX2010 DIP switch
configuration.
Figure 37: DX2010 DIP Switch
Configuration
1
ON
1 2
1- OFF position
2- ON position
Sample address setting shown is for Address
102
2.6.10 DX2010 Status LED
See the following for Status LED operation:
• One flash per second indicates normal
operation.
• LED steady ON can indicate any of the
following:
Power, no communication.
-
"G" wire is not connected or there is a
-
communication problem between the
control panel and the DX2010.
No locations (zones) are assigned to the
-
DX2010 with this address. See Location
##, Zone Function on page 83 for details.
DX2010 address is not set correctly.
-
• LED OFF indicates that there is no power to
the module.
Figure 38: DX2010 Status LED Location
1- DX2010 DIP Switches
2- DX2010 Status LED
EN | 28
OFF ON ON
2
3 4 5 6
ON
1
1 2 3 4 5 6
2
OFF