Bosch DS7200V2-EXP Installation Manual page 42

DS7200V2-EXP | Installation Guide | 2. System Installation
and Setup
2.15.6 Output Test
When you press [6] for Output test, the display
shows "Output 1, Press * for All On." If the
output is already on, then the display shows
"Output 1, Press * for All Off."
Press and hold [*] to toggle the output state.
Press [*] (without holding) to end current output
test and to advance to next output.
2.15.7 RF Menu
Press [7] to enter the RF Menu.
This menu consists of choices that allow you to
add RF ID codes, test RF devices or view/remove
RF ID codes.
Adding RF ID Codes
Enter RF ID codes after programming
the control panel from a keypad. You
can enter RF ID codes at any time
when using RPS.
Before an RF ID can be added, corresponding
locations must first be programmed as RF
devices.
1. Press [1] from the RF Menu to add RF ID
codes into the system, The display then
scrolls all locations requiring RF IDs:
Location Area
Loc9
To add push 9*.
2. To add an RF ID to the system as shown in
the display above (Location 9 used as an
example), press [9] followed by [*]. The
following display appears:
Enter ID for
Loc9
3. Enter the 9-digit ID code found on the back of
the RF device and then press [#]. "ID added,
press #" appears on the second line of the
display, indicating that the code has been
successfully entered and accepted. Press [#].
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
Zone
Number
A1 Zn9
A1 Zn9
If an error message appears instead of
"#," make sure you enter the code as
printed on the back of the device and
that you only enter 9 digits.
4. Press [#]. The display returns to the first
location designated as a RF device without an
ID and scrolls through other RF device
locations (if any). You may enter the desired
location number and add the ID code as
described above.
5. When all RF ID codes are entered, press [#]
twice. The display shows "Configuring RF,
please wait." During this period, the RF
Receiver's LED blinks approximately once
every second until all ID bytes have been
recognized. If the devices are successfully
configured, the display returns to the
scrolling RF Menu.
If an error message appears, make
sure the RF Receiver's is wired to the
control panel correctly, and that no
shorted conditions are present.
6. Press [1] to enter additional RF ID codes or
select one of the other RF Menu choices. If
you are finished with the RF Menu, press [#]
to return to the main programming menu.
RF keypads are assigned using Locations 41
to 44. Only 4 per system are allowed (1 per
Location). RF keypads are identified by "Kp"
(see the following display).
Enter ID for
Loc41
RF keyfobs are assigned using Locations 45
(User 1) to 76 (User 32). RF keyfobs are
identified by "Kf" (see the following display).
Enter ID for
Loc45
For the DS7240V2, 32 RF keyfobs are
available if RF Receivers 1 and 2 are both
connected to the system. For the DS7200V2,
all 32 RF keyfobs are always available.
EN | 42
Kp1
Kf1