Bosch DS7200V2-EXP Installation Manual page 114

DS7200V2-EXP | Installation Guide | 4. Reference Materials
Table 40: Control Panel Events and Reporting Formats (continued)
Event Event as shown
in Control Panel
Log
87 Missing,Alarm
88 Missing,Trouble
89 Open,Skd
90 Open,RPS
91 Open,Usr
92 Open,KS
93 Open,Skd,Alarm
94 Open,RPS,Alarm
95 Open,Usr,Alarm
96 Open,KS,Alarm
97 Reserved
98 Params Changed
99 Phone Line Fail
100 Phone Line Rstl
101 Bad Call to RPS
102 RPS Access Fail
103 RPS Access OK
104 Re-Boot,Panel
105 Re-Boot,Dbus
106 Output Reset,Usr
107 Output Reset,Skd
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
SIA Report Contact ID
Report
UZ Untyped 150 General
Missing Alarm Alarm
UY Untyped 382 Loss of
Missing Trouble supervision –
RPM
OA Automatic 403 Automatic
Opening O/C
OQ Remote 400
Opening Open/Close
OP Opening 401 O/C by
Report User
OS Opening 409 Keyswitch
Keyswitch O/C
OR Disarm from 403 Automatic
Alarm O/C
OR Disarm from 400
Alarm Open/Close
OR Disarm from 401 O/C by
Alarm User
OR Disarm from 409 Keyswitch
Alarm O/C
YG Parameter 306 Panel
Changed Programming
Changed
LT Phone Line 351 Telco 1
Trouble fault
LR Phone Line 351 Telco 1
Restoral fault
RA Remote 413
Programmer Call Unsuccessful
Failed access
RU Remote 413
Unsuccessful
Program Fail
access
RS Valid Remote 412
Access Successful
Download/Acc
ess
RR Power Up 305 System
reset
RR Power Up 339 Exp.
Module Reset
RO Relay Open 320
Sounder/Relay
RO Relay Open 320
Sounder/Relay
Event Description
Zone assigned to zone expander
(wired or RF) not responding to
panel's status poll while the area
is armed.
Zone assigned to zone expander
(wired or RF) not responding to
panel's status poll while the area
is disarmed.
Opening by Sked.
Opening by RPS.
Opening by user, ID reported.
Opening by Keyswitch.
Opening after Alarm event by
Sked.
Opening after Alarm event by
RPS.
Opening after Alarm event, ID
reported.
Opening after Alarm event by
Keyswitch.
Panel Parameters Changed.
Phone line voltage less than 3
volts for 40 sec.
After Phone Line Fail event,
phone line voltage detected at
greater than 3 volts for 40 sec.
Panel attempted call to RPS, but
was unsuccessful.
RPS attempted to connect to
panel but was not successful.
RPS successfully connected to
and disconnected from panel.
Normal start up or reset after
programming.
Unexpected reset (reboot) from
Data Bus device.
Output Reset by User
Output Reset by Sked
EN | 114
Zone Types RPS
Linked to Event
Event Group
6- 24-hr Burg 3
10-15 Zone
Types
3-8, 10-15 Zone 6
Types
10
10
10
10
10
10
12
12
12
12
12
16
16
Status
Report
R
R S
R S
R
R
R
R S
R S
R
R