Bosch DS3MX-E-U Operation Manual

1 | Arm the system
Arming the system:
1. Enter a Master PIN code or a User PIN code.
2. Press [On]. If the code was entered correctly, the red Armed indicator
flashes and the system arms.
If your system has an exit delay zone, the sounder beeps during the exit
period. The exit sounder beeps faster during the last 20 seconds of the
programmed exit delay time.
After the exit delay time expires, the red Armed indicator stays on
continuously. A violation on a zone, not programmed as a delay zone,
immediately activates a system alarm.
2 | Disarm the system
Disarming the system:
1. Enter a Master PIN code or a User PIN code.
2. Press [Off].
If a delay zone is triggered first, a code must be entered before the
expiration of the entry delay time. The red Armed indicator LED stops
flashing and turns off, indicating the system is disarmed. Refer to Table
10.1.
3 | Quick Arm
Activating Quick Arm:
If your system is programmed by the installer to allow Quick Arm, press
and hold [On] for 3 seconds to start the arming mode.
To disarm, refer to Section 2.
4 | Cancel alarm
Canceling an alarm:
1. Enter a Master PIN code or a User PIN code
2. Press [Off] to immediately stop the alarm output.
5 | Panic key
NOTICE!
Your system must be programmed at installation to use this
function.
Using the panic function:
During an emergency, simultaneously press [*] and [#] for 3 seconds to
produce an alarm.
Entering a User code resets the panic alarm condition.
6 | Clear alarm history
Clearing alarm history:
While in the disarmed mode, press [#] for 3 seconds to cancel all flashing
alarm history zone indicators.
If an alarm occurs while the system is armed, the zone's LED stays on
continuously. Refer to Table 10.1.
When the system is disarmed, the LED of the zone causing the alarm
flashes.
While in the disarmed mode, press [#] for 3 seconds reset the indicator.
7 | Bypass a zone
A user can bypass a zone during the arming sequence if it was
programmed at installation to allow bypass. You can bypass a zone if the
zone is either faulted or normal.
Bypassing a zone:
1. Enter the User code or the Master code.
2. Press [Bypass].
3. Enter the zone number to bypass (such as, Zone 1, Zone 2, or Zone 3, or
any combination of Zones 1, 2, or 3).
For example, to enter Zone 1, press [1], then press [On] to begin the
arming cycle and exit delay, if programmed. All bypassed zones clear and
automatically restore to normal mode the next time the system disarms.
Once a zone is bypassed, the zone's LED indicates bypass status by
flashing twice every 2 seconds. Refer to Table 10.1.
8 | Fire alarm reset
NOTICE!
Your system must be programmed at installation to use this
function.
Only the Master code user can perform this function.
Resetting the fire alarm:
Use the Fire Reset for power interrupt, and to reset the smoke detectors.
9 | Door unlock code/Request to Exit
Activate Request to Exit (REX) function:
If enabled, entering the Door Un-lock User code and pressing [*] activates
the REX function. This function releases any connected door lock.