4
BODY AND TRIM
FRONT FLOOR MAT INSTALLATION
1. Install the floor mat in the reverse order of removal.
2. Install the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group.
REAR FLOOR MAT REMOVAL – TURF 6 AND CARRYALL 6 ONLY
1. On the driver or passenger side of the vehicle, gently pry the edges of the floor mat and pull the floor mat
in the direction of the front of the vehicle so that it is no longer under the lip of the body located directly
behind the floor mat.
2. Slightly bend the floor mat on each side of the vehicle to free it from the center body assembly located
in front of the floor mat.
3. Lift the floor mat from the vehicle.
REAR FLOOR MAT INSTALLATION – TURF 6 AND CARRYALL 6 ONLY
1. Install the floor mat in the reverse order of removal.
BUMPER
See General Warning, Section 1, Page 1-1.
BUMPER REMOVAL
1. Remove four lock nuts (10), six flat washers (11), four phillips bolts (12), and mounting plate (9) from rear
bumper (8) (Figure 4-6, Page 4-14).
2. Lift bumper from vehicle.
BUMPER INSTALLATION
1. Install the rear bumper in the reverse order of removal. Tighten nuts to 65 in-lb (7.3 N·m) (Figure 4-6,
Page 4-14).
Page 4-16
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Bumper