Key Switch - Club Car 2005 FE290 Maintenance Service Supplement

ELECTRICAL COMPONENTS
6. Place Forward/Reverse handle in NEUTRAL and place the neutral lockout cam in the SERVICE (MAIN-
TENANCE) position. Start the engine and check regulator for proper functioning as described in the volt-
age regulator test procedure. See Test Procedure 11, Section 11, Page 11-18.

KEY SWITCH

See General Warning, Section 10, Page 10-1.
Testing the Key Switch
See Test Procedure 17, Section 11, Page 11-27. See Test Procedure 4, Section 11, Page 11-12.
Key Switch Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Remove the center dash panel.
2.1. Remove the plastic cap (1) covering the mounting screw (2) on each side of the center dash panel
(Figure 12-16, Page 12-13).
2.2. Loosen, but do not remove, the screw (2) on each side of the center dash panel (3).
2.3. Insert screwdriver at the top center of the dash between dash and cowl brace. Gently pry center
dash out slightly from under edge of cowl brace.
2.4. Pull center dash out approximately 1 inch (2.5 cm) from the frame and then bend the top right cor-
ner of the center dash inward while pulling the top of the panel out and down. See following NOTE.
NOTE: Bending the top right corner of the center dash inward during removal will prevent the terminals on
the back of the key switch from touching the metal frame around the dash.
2005 FE290 Gasoline Vehicle Maintenance and Service Supplement
3
Figure 12-16 Center Dash Panel Removal
12
Key Switch
A
2
1
Page 12-13