Configuring Basic Settings With A Configuration Editor - Juniper J-series Services Router J2350 Hardware Manual

JUNOS Software with Enhanced Services Hardware Guide
Table 43: Basic Configuration Wizard Summary (continued)
Prompt
Would you like to create a new user account? [yes,
no] (no):
If you enter , the configuration wizard
y(es)
displays the following prompt:
Enter a new user name:
After you enter a username, the configuration
wizard prompts you for an associated password.
Enter user password
After you enter the password, the configuration
wizard requests that you verify it.
Retype the password:
SNMP
Would you like to configure SNMP Network
Management? [yes,no] (no):
If you enter y(es) , the configuration wizard
presents the following prompt:
Enter community string [public]:

Configuring Basic Settings with a Configuration Editor

To establish basic connectivity on a Services Router, you identify the router, connect
the router to the network, and specify basic network settings.
In a typical network, the Services Router has the basic settings listed in
Table 44 on page 110. Determine the values to set on the Services Router in your
network.
Table 44: Sample Settings on a Services Router
Services Router Property
Services Router hostname
Access for user "root"
IP address of the NTP server used to synchronize system time
on the Services Router
Services Router location
110
Configuring Basic Settings with a Configuration Editor
Function
Defines a new (non-root) user account.
Configures the Simple Network
Management Protocol parameters. The
SNMP community string defines the
relationship between an SNMP server
system and the client systems. The
string serves as a password to control
the client's access to the server.
Sample Value
routera
SSH RSA public key
10.148.2.21
Sunnyvale, California, USA, which is in the
America/Los_Angeles
Your Action
Type a username composed of
only alphanumeric characters, the
hyphen character, and the
underscore character.
For the password, you must enter
a value that is no less than 6 and
no more than 128 characters
long. It must contain at least 1
uppercase character and 1
lowercase character. It can
include numbers and special
characters.
Type the SNMP community
string.
time zone