Set Snapshot Virtual Disk - Dell PowerVault MD3220 Cli Manual

Parameter
performanceMonitorInterval
performanceMonitorIterations The number of samples to capture. Enter
Additional Information
When you use this command, you can specify one or more of the optional
parameters.
Passwords are stored on each storage array in a management domain. If a
password was not previously set, you do not need a password. The password
can be any combination of alphanumeric characters with a maximum of 30
characters. (You can define a storage array password by using the set
storageArray command.)
The polling interval and the number of iterations that you specify remain in
effect until you end the session. After you end the session, the polling interval
and the number of iterations return to their default values.

Set Snapshot Virtual Disk

This command defines the properties for a snapshot virtual disk and lets you
rename a snapshot virtual disk.
Syntax
set (virtualDisk [virtualDiskName] |
virtualDisks [virtualDiskName1 ...
virtualDiskNameN])
userLabel="snapshotVirtualDiskName"
warningThresholdPercent=percentValue
repositoryFullPolicy=(failSourceWrites |
failSnapshot)
Description
The frequency of gathering performance
data. Enter an integer value for the
polling interval, in seconds, for which you
want to capture data. The range of values
is 3 to 3600 seconds. The default value is
5 seconds.
an integer value. The range of values for
samples captured is 1 to 3600. The
default value is 5.
Script Commands
205