Dot1Q-Tunnel Configuration; Commands For Dot1Q-Tunnel Configuration - Edge-Core ES4624-SFP Manual

It is obvious that, the dot1q-tunnel function has got following characteristics:
Applicable through simple static configuration, no complex configuration or
maintenance to be needed.
Operators will only have to assign one SPVID for each user, which
increases the number of concurrent supportable users; while the users has
got the ultimate freedom in selecting and managing the VLAN IDs (select
within 1~4094 at users' will).
The user network is considerably independent. When the ISP internet is
upgrading their network, the user networks do not have to change their
original configuration.
Detailed description on the application and configuration of dot1q-tunnel of ES4624
will be provided in this section

5.3.2 Dot1q-tunnel Configuration

5.3.2.1 Configuration Task Sequence Of Dot1q-Tunnel
1) Configure the dot1q-tunnel function on the ports
2) Configure the type of protocol (TPID) on the ports
1. Configure the dot1q-tunnel function on the ports
Command
Port mode
dot1q-tunnel enable
no dot1q-tunnel enable
2. Configure the type of protocol (TPID) of the port
Command
Port mode
dot1q-tunnel
{8100|9100|9200|<0-65535>}

5.3.3 Commands for Dot1q-Tunnel Configuration

5.3.3.1 dot1q-tunnel enable
Command: dot1q-tunnel enable
Explanation
Enter/exit the dot1q-tunnel mode on
the ports.
Explanation
Configure the type of protocol on the
tpid
ports.
187