Edge-Core ES4624-SFP Manual page 589

command is for setting the route which do not switch the specified address family
Parameter: <ip-address>: IP address of the neighbor
<TAG>: Name of peer group
Default: Enable the routing switch of IP unicast address-family, and disable other
address-families
Command Mode: BGP route mode and address-family mode
Usage Guide: IP unicast is configured under BGP route mode. Configure whether
specific address-family is switched under address-family mode. If this option on any side
between local side and partner is not enabled, the address-family route will not be
acquired by the partner even if the corresponding address family routes acquired before
will be cancelled after this option is disabled.
Example:
Switch(config-router)#neighbor 10.1.1.64 activate
Switch(config-router)#address-family ipv4
Switch(config-router-af)#no neighbor 10.1.1.64 activate
Switch(config-router-af)#
17.8.3.39 neighbor advertisement-interval
Command: neighbor {<ip-address>|<TAG>} advertisement-interval <0-600>
no neighbor {<ip-address>|<TAG>} advertisement-interval [<0-600>]
Function: Configure the update interval of specific neighbor route. the "no neighbor
{<ip-address>|<TAG>} advertisement-interval [<0-600>]" command restores to default
<ip-address>: IP address of the neighbor
Parameter:
<TAG>: Name of the peer group
<0-600>: Advertise interval, in seconds
Default: Default IBGP is 5s, default EBGP is 30s
Command Mode: BGP route mode and address-family mode
Usage Guide: Reduce this value will improve the route updating speed while also
consumes more bandwidth.
Example:
Switch(config-router)#neighbor 10.1.1.64 advertisement-interval 20
Switch(config-router)#no neighbor 10.1.1.64 advertisement-interval
Switch(config-router)#
17.8.3.40 neighbor allowas-in
Command:neighbor {<ip-address>|<TAG>} allowas-in [<1-10>]
no neighbor {<ip-address>|<TAG>} allowas-in
Function: Configure the counts same AS is allowed to appear in the neighbor route AS
589