Edge-Core ES4624-SFP Manual page 545

Example: Switch#config terminal
Switch(config)#router ipv6 ospf
Switch(config-router)#passive-interface vlan1
17.7.3.17 redistribute
Command: [no]redistribute {kernel |connected| static| rip| isis| bgp} [metric<value>]
[metric-type {1|2}][route-map<word>]
Function: Introduce route learnt from other routing protocols into OSPF
Parameter: kernel Introduct from kernel route
connected Introduce from direct route
static Introduce from static route
rip Introduce from the RIP route
isis Introduce from ISIS route
bgp Introduce from BGP route
metric <value> is the introduced metric value, ranging between 0-16777214
metric-type {1|2} is the metric value type of the introduced external route, which
can be 1 or 2, and it is 2 by default
route-map <word> targets to the probe of the route map for introducing route
Command Mode: OSPFv3 protocol mode
Usage Guide: Learn and introduce other routing protocol into OSPF area to generate
AS-external_LSAs
Example: Switch#config terminal
Switch(config)#router ipv6 ospf
Switch(config-router)#redistribute bgp metric 12 metric-type 1
17.7.3.18 router-id
Command: router-id<router-id>
no router-id
Function: Configure router ID for ospfv3 process. The "no router-id"restores ID to
0.0.0.0
Parameter: <router-id>> is the router ID shown in IPv4 format
Default: 0.0.0.0 by default
If the router-id is 0.0.0.0, the ospfv3 process can not be normally
Usage Guide:
enabled. It is required to configure a router-id for ospfv3
Command Mode: OSPFv3 protocol mode
Example: Switch#config terminal
Switch(config)#router ipv6 ospf
Switch(config-router)#router-id 192.168.2.1
545