Commands For Cluster - Edge-Core ES4624-SFP Manual

Command
Global Mode
cluster auto-add enable
no cluster auto-add enable
cluster holdtime < second>
no cluster holdtime
cluster heartbeat <interval>
no cluster heartbeat
clear cluster candidate-table
4. Configure attributes of the cluster in the candidate switch
Command
Global Mode
cluster register timer <timer-value>
no cluster register timer
5. Remote cluster network management
Command
Admin Mode
rcommand member <mem-id>
rcommand commander
cluster reset member<mem-id>
cluster update
<src-url> <dst-url> [ascii | binary]

27.1.3 Commands for cluster

27.1.3.1 cluster run
member <mem-id>
Explanation
Enable or disable adding newly discovered
candidate switch to the cluster
Set holdtime of heartbeat of the cluster
Set interval of sending heartbeat packets
among the switches of the cluster
Clear the list of candidate switches
discovered by the commander switch
Explanation
Set interval of sending cluster register
packet
Explanation
In the commander
command is used to configure and
manage member switches.
In the member switch, this command is
used to configure the member switch
itself.
In the commander
command is used to reset the member
switch.
In the commander
command is used to remotely upgrade
the member switch. It can only
upgrade nos.img file.
923
switch, this
switch, this
switch, this